|
|
|
|
|
|
|
|
||||
 |
 |
 |
 |
Pre-Terminated Fibre Optic Cabling |
|
ST & SC Standard Connector options - other connector types on request |
Fibre Counts of 4, 8, 12 & 16 |
|
Fast Manufacturing Lead Times |
|
Low Installed Cost |
|
50/125, 62.5/125 or Singlemode Fibre |
| Fibreco manufactures a low cost pre-terminated cabling solution, which combines the benefits of using standard connectors and tight buffered cable with greatly reduced installation times. |
| These high quality factory terminated cables may be used for simple point to point links or to install a complete fibre optic network. The cabling is fully compatible with all standard cable management accessories and requires no special tools or expertise to install. |
| The cables are fitted with a gland and special pulling head, which is attached to the cable strength member. This fully protects the connectors during installation and allows the cables to be pulled through ducts without applying load to the terminations. |
| Fibreco pre-terminated cabling is fully tested in the factory and is supplied with an attenuation test certificate and installation instructions. |
Outline Specifications |
| Connector Performance: |
| Multimode | Singlemode | |||
| ST, SC & LC Connectors | ST, SC, LC & FC Connectors | |||
| Insertion Loss | Insertion Loss | Return Loss | ||
| Typical | <-0.3dB | Typical | <-0.2dB | SPC: >45dB |
| Maximum | -0.5dB | Maximum | -0.4dB | UPC: >55dB |
| Spacing | Spacing | Spacing | Spacing | APC:>60dB |
| Cable Characteristics: Tight Buffered internal / external specification |
|
Fibre Count |
Cable Dia (mm) |
Weight (kg/km) |
Sheath Material |
Min Bend Radius |
Installation Tension |
Crush Resistance |
Operating Temp (°C) |
| 4 | 5.5 | 26 | LSZH | 55mm | 800N | 300N/cm | -20 to +60 |
| 8 | 6.0 | 32 | 60mm | 900N | |||
| 12 | 6.5 | 40 | 65mm | 1000N | |||
| 16 | 7.5 | 47 | 75mm | 1200N |
| Multimode Fibre Characteristics: |
| Fibre Type | Attenuation dB/km | Bandwidth MHz/km | NA | ||
| 850nm | 1300nm | 850nm | 1300nm | ||
| 62.5/125 | 3.5 | 1.5 | 200 | 500 | 0.27 |
| 50/125 OM2 | 3.0 | 1.0 | 500 | 800 | 0.20 |
| 50/125 OM3 | 3.0 | 1.0 | 1500 | 500 | 0.20 |
| Singlemode Fibre Characteristics: |
| Attenuation dB/km | Dispersion ps/nm.km | |||
| 1310nm | 1550nm | 1310nm | 1550nm | |
| 9/125 | 0.40 | 0.28 | 3.5 | 18.0 |
|
Pulling Head Characteristics Maximum Diameter: 28mm Maximum Tensile Load: 1000N A Swivel and appropriate Fuse Pin must be used when pulling through ducts |
 Printer-Friendly Version (PDF)
|
| Product Navigator: | |||
|